Resources

Monitors may have slightly different sized bases and frames, but if you are using a modern monitor from one of the large manufacturers, you should be able to fit two monitors side by side up to 24”. Alternatively, you can secure your monitors to the Lotus™ with a Lotus™ Dual Monitor Arm. View the Lotus™ Monitor Arm here.

No, the Lotus™ was designed as a stand-alone sit stand that can sit on top of the desk and has been independently tested to ensure stability. The workstation should be placed on a flat surface that can accommodate the entire width and depth of the product without overhang.

The Lotus™ has rubber feet that help protect the desk from scratching the surface of your desk.

Under normal use, the platform is stable. If you want to maximize the durability of the product, please do not lean or apply excessive force to the keyboard platform.

Ensure your workstation is raised to the highest position and all of your items are placed on it. As per the image below, turn the knob clockwise (toward the + sign) for heavier weights and counter clockwise (towards the – sign) for lighter weights. Lotus™ is shipped at the lowest setting which is 4.5kg to get to the highest setting 15.8kg is 27 full rotations. For example, if you have two monitors that weigh 4.5kgs each and a keyboard and mouse that combined weigh 1.4kgs, you would turn the knob clockwise approximately 14 full rotations. The exact number of rotations depends on your personal comfort raising and lowering the platform. This is just a guideline.

These are meant for single use as specified in the manual. We have spare parts for purchase that we can supply. Please contact our customer services team on 00800 1810 1810 who will be happy to help.
Additionally you could also go to your local hardware store and purchase adhesive Velcro discs (3.5mm).

There are three locations in the rear cable channel that you can choose from. Find the slot that will best accommodate your setup and place the cable funnel into the slot. You will feel it magnetically attach to the Lotus™. The cable funnel should now be in place.

First you will need to clamp the cable zip tool around all cables below the cable funnel (make sure the arrow on the cable zip tool is pointing upward). Next, take the cable zip and push upward into the tool so that the cable zip beings wrapping around the tool. Make sure the seam of the cable is facing the tool. Once it’s started, pull downward on the cable zip tool while holding the top of the cable zip. Continue sliding the tool until all cables are in the cable zip. Please refer to step 3 in the instruction manual.

Most cable lengths are an average of 2m, which should be sufficient for working when standing however it would be important to consider where the power sockets are located. The Lotus™ Sit-Stand™ Workstation raises 432mm above the desk. Ensure the Lotus™ is in the highest position when putting items on to ensure proper cable length.

Use a soft, clean, dry cloth.

Yes, our product has been independently certified by FIRA international, an independent ergonomic accreditor, to comply with EU Health and Safety legislation: EN ISO9241 Ergonomic requirements for office work with visual display terminals (VDT’s): Part 5: 1999, workstation layout and postural requirements.

5 years. Please see the product manual for full terms and conditions.