Resources

The Levado base accommodates a variety of desktop sizes.
Width: 1220mm - 1829mm
Depth: 610mm - 800mm
Thickness: 19mm - 31.15mm

Make sure your table top is face down on a soft, clean surface and place base on table. Use the 5mm Allen key to loosen the (8) set screws on the inward side of the cross channels. Expand or contract accordingly until the ends are flush with the table top. Re-secure the (8) set screws. Refer to step 1B in the instruction manual.

You can use the VersaTop Clamps™ to install your current table top onto the Levado base. Ensure that the table top is within the following measurements:
Width: 1220mm - 1829mm
Depth: 610mm - 800mm
Thickness: 19mm - 31.15mm.
Refer to install option 1 in the instruction manual.

There are two groups of memory settings, each with two height settings. To toggle between the two users momentarily press the M button and display will read U1 or U2. Up to four memory stop positions can be used to save specific heights of the work surface. To set a specific position: Raise or lower the table to the position you want to save. Press and hold the M button for two seconds, the LED display will blink. This means it has stored the location.

To clear storage settings, press and hold M button for 8 seconds until CLR displays.

To change the measurement unit, press and hold up and down at same time for 10 seconds.

This will depend on your setup. If any of your cables are routing to the floor be sure that they can accommodate the full range of motion up to 1260mm. Refer to Accessory Installation Step 1 in the instruction manual.

The Levado base is quiet in operation and has a decibel rating range of 46-48.

Contact Fellowes Customer Service team and we will be glad to assist you 00800 18101810.

If the table feels unbalanced adjust the (4) levelling pads located on the bottom of the feet. Turn clockwise to lower and counter clockwise to raise.

The three stage legs provide height adjustment from 640mm to 1260mm, when using a standard 25mm worktop.

The Levado base is made out of powder coated steel, and the Levado worktops are made out of sustainably sourced (PEFC) MFC (Melamine Faced Chipboard) with a 2mm PVC edging.

Our Levado frame has a height range of 61.5cm to 123.5cm. The Levado comes programmed to show a minimum height of 64cm, as a standard desktop is 25mm thick (all Fellowes desktops are also 25mm thick).

However, if your desktop thickness differs from this, you can reprogram the handset to show a different minimum height.

How to adjust the minimum height setting:

1. Place your table at the minimum height by pressing DOWN button.
2. Lightly press and hold the UP and MEMORY [M] buttons for 5 seconds until the first number (leftmost) on the handset display starts to blink (alternates between number and “-“).
3. Lightly press UP or DOWN buttons to adjust the blinking number on the display.
4. Lightly press MEMORY [M] to accept the number input and the blinking will move to the next rightmost number.
5. Repeat steps 3-4 until all numbers are set and the display stops blinking. Your initial height is now set, and the table will increment from this point.

Fellowes, Inc. (the “Company”) warrants the Levado™ Height Adjustable Desk Base (“Product”) to be free from defects in material and workmanship for the time period as set forth below.

The structural frame for a period of fifteen (15) years from the date of original purchase of the product.

All electrical components for a period of seven (7) years from the date of original purchase of the product.

The desktop for a period of ten (10) years from the date of original purchase of the product.

Refer to the manual for full details.